Skip to content

Battery self-loading die cart – Capacity 15 ton

Morello designed and manufactured a self-loading die cart to the handling of dies and molds up to 15 tons for automotive industry.
Thanks to its n°4 hydraulic cylinders it can lift by itself a steel structure with a die on it and transport it where needed, avoiding the usage of overhead cranes. This system allow to increase significantly productivity and safety, saving time and avoiding suspended loads.
Therefore this transfer cart is very flexible since it can move freely around the plant as indoor as outdoor.
When hydraulic cylinders are lowered the loading deck is completely flat and the die cart can be used to transport any kind of heavy load.
It is equipped with non-marking wheels to avoid any mark on floor.
This transfer trolley is powered by a battery and it is driven by n°2 AC motors.
Dimensions, loading platform superstructure, speed and many others features can be customized as per customer request.
Morello produce also a wide range of carts to handle dies and molds up to over 500 ton. Here some examples: battery powered trolleys on wheels

15 tonnes – 2.500 x 1.250 mm

Main features:

Power supply: Battery (diiferent kind of batteries on request)
Engine: AC motors
Capacity: 15 ton (over 500 tons on request)
Dimension: 2.500 x 1.250 mm (customized dimensions on request)
Travel speed: 20 m/min with full load (different speeds on request)
Lifting stroke: 100 mm (higher stroke on request)
Wheels: N°4 rubber wheels
Battery life: 4 hours (different autonomy on request)
Command: potentiometric radio remote controller
On request: ATEX / IEC Ex / Hazloc conform

It may also interest you